The reason why hot water is coming from your cold tap in the summer is most likely due to those plastic cold water lines heating up in the attic. Due to your attic’s extreme heat, those thin plastic water lines heat up extremely fast causing water to come out of the cold tap warm or hot.

It helps a bit, pouring water on floor and then starting a fan will help cool the room faster. When the water evaporates it uses heat from room to evaporate thus cooling the room.

If a vapor barrier has been poorly installed, puddles can form on top of the liner (see photo). Because the crawl space is a below-grade space under the house, you might think it’s normal to have a moist crawl space. After all, the ground gets wet and dry through the seasons and with weather patterns event.

It is normal because usually the height of the water does not exceed the height of the gravel that you install when back filling the hole. And it will not cause any problems moving forward either.

Water is a bitter foe of all the basements. YES, water around your foundation can come up through the concrete floor and can leave any material on its way soggy and damaged.

However, concrete is porous. No, water isn’t going to soak up like a sponge, but concrete does allow water to seep through when there is enough. Concrete also cracks, and those cracks will be the first routes of seeping water as it leaks through the slab.

When it rains, water is absorbed into the ground until the earth is too saturated to soak up any more water. At this point, the water will begin to rise to the surface, causing hydrostatic pressure to build up against your foundation and basement floors, which leads directly to water seepage into your home.

Seal the Floor Use a sealer designed for concrete moisture protection, such as an epoxy concrete sealer, which often comes in two parts that must be mixed immediately before applying. Pay special attention to the corners and edges of the floor, where cracks can let extra moisture seep in.

Seal Your Basement or Garage Floor – The proper method is to deep seal the concrete floor first with RadonSeal Concrete Sealer. RadonSeal provides the permanent waterproofing solution for concrete slabs by stopping capillary water seepage due to hydrostatic pressure or wicking water.

Penetrating Concrete Sealer Prevents Moisture Problems Unwanted wetness deep within concrete can eventually make its way to the surface, causing problems like: Organic growth such as mold and mildew beneath mats and non-air permeable coverings.

Here are eight strategies to keep water out of your basement.

1. Add Gutter Extensions.
2. Plug Gaps.
3. Restore the Crown.
4. Reshape the Landscape.
5. Repair Footing Drains.
6. Install a Curtain Drain.
7. Pump the Water.
8. Waterproof the Walls.

One of the biggest causes of wasted water in your home is a slow leak in your pipes, plumbing fixtures and appliances, especially water leaks behind walls. Because these leaks are generally silent, they often go undetected. Your Roto-Rooter plumber can detect and repair any water leak.

Condensation occurs when hot, moist air hits cold, dry air. This meeting causes water droplets to form on the cold surfaces (like your walls). This kind of moisture is what you’ll find on the bathroom walls after a super-hot shower.

Average Cost to Waterproof a Basement According to the online estimates and calculators, waterproofing a basement can cost on average anywhere between $1,920 and $6,493. Per square foot, the average cost is $3 to $10.

use a Hydraulic Cement to plug any holes or large crack on the wall. Follow directions for the cement and clean out loose stones or cement before applying this product. Paint the Outside Wall with a Cement Waterproofing Sealer- After wall dries brush on a waterproof paint-sealer used for outside walls.

The average homeowner spends around $4,576 to waterproof a basement or foundation, with minor repairs costing as little as $600. More comprehensive issues that include fixing cracks in the foundation or adding drains & gutters can cost upwards of $10,000.

Foundation Repair Cost Most homeowners will pay around $4,546 to repair foundation issues. Major repairs involving hydraulic piers can cost $10,000 or more, and minor cracks cost as low as $500. The typical homeowner pays between $2,014 and $7,080.

Yes, serious foundation issues do put your home’s stability at risk. This is why, if a foundation wall collapses, you need a structural engineer or a highly qualified contractor to assess the damage. The basement wall is cracked horizontally and bowing inward.

Best Methods of Foundation Repair

• Underpinning.
• Shimming using supplemental piers.
• Foundation wall repair.
• Water Management.
• Shimming using existing piers.
• Grouting.
• Mudjacking.
• Stabilizing foundation soil.

The average cost to lift a house and replace the foundation is $20,000 to $100,000, depending on the home’s size, accessibility, and support required. Without house lifting, replacing a foundation costs $5 to $30 per square foot or $5,000 to $50,000 on average, depending on the type.

Slab jacking is a type of concrete lifting that fills any voids under the slab, then raises the floor back up. The costs for slab jacking begin at $2000, and will increase depending on how much material is needed and how large the area is to complete the repair.

It is difficult, if not virtually impossible, for a non-professional to jack up his or her house. But there are some realities about house jacking that make it more difficult and complicated than it may seem, and it very likely would take longer than you’d expect.

Place the jack beneath the sinking beam. Jack up the beam so that the house is level. Use the other, nonsagging beams as your ideal so that you can bring all of the house’s beams back into a level arrangement. Jack the beam up slowly so that it can gradually shift and readjust until level again.